In this paper, we investigate covert communication over millimeter-wave (mmWave) frequencies. In particular, a mmWave transmitter, referred to as Alice, attempts to reliably communicate to a receiver, referred to as Bob, while hiding the existence of communication from a warden, referred to as Willie. In this regard, operating over the mmWave bands not only increases the covertness thanks to directional beams, but also increases the transmission data rates given much more available bandwidths and enables ultra-low form factor transceivers due to the lower wavelengths used compared to the conventional radio frequency (RF) counterpart. We first assume that the transmitter Alice employs two independent antenna arrays in which one of the arrays is to form a directive beam for data transmission to Bob. The other antenna array is used by Alice to generate another beam toward Willie as a jamming signal while changing the transmit power independently across the transmission blocks in order to achieve the desired covertness. For this dual-beam setup, we characterize Willie's detection error rate with the optimal detector and the closed-form of its expected value from Alice's perspective. We then derive the closed-form expression for the outage probability of the Alice-Bob link, which enables characterizing the optimal covert rate that can be achieved using the proposed setup. We further obtain tractable forms for the ergodic capacity of the Alice-Bob link involving only one-dimensional integrals that can be computed in closed forms for most ranges of the channel parameters. Finally, we highlight how the results can be extended to more practical scenarios, particularly to the cases where perfect information about the location of the passive warden is not available.
相關內容
Practical Hybrid Beamforming for Millimeter Wave Massive MIMO Full Duplex with Limited Dynamic Range
In this paper, we present a novel hybrid beamforming (HYBF) design to maximize the weighted sum-rate (WSR) in a single-cell millimeter-wave (mmWave) massive multiple-input-multiple-output (MIMO) full duplex (FD) system. Compared to the traditional HYBF designs, we consider the joint sum-power and the practical per-antenna power constraints. The multi-antenna users and the hybrid FD base station (BS) are assumed to be suffering from the limited dynamic range (LDR) noise due to non-ideal hardware. The traditional LDR noise model is first extended to the mmWave and an impairment-aware HYBF approach is adopted. A novel interference, self-interference (SI) and LDR aware optimal power allocation scheme for the multi-antenna uplink (UL) users and the hybrid FD BS is also presented. The analog processing stage is assumed to be quantized, and both the unit-modulus and the unconstrained cases are studied. The maximum achievable gain of a multi-user mmWave FD system over a fully digital half duplex (HD) system with different levels of the LDR noise variance and different numbers of the radio-frequency (RF) chains is investigated. Simulation results show that the proposed HYBF design outperforms the fully digital HD system with only a few RF chains at any LDR noise level. The advantage of having amplitude control at the analog stage is also examined and additional gain is evident when the number of RF chains at the FD BS is small.
We introduce a gossip-like protocol for covert message passing between Alice and Bob as they move in an area watched over by a warden Willie. The area hosts a multitude of Internet of (Battlefield) Things (Io\b{eta}T) objects. Alice and Bob perform random walks on a random regular graph. The Io\b{eta}T objects reside on the vertices of this graph, and some can serve as relays between Alice and Bob. The protocol starts with Alice splitting her message into small chunks, which she can covertly deposit to the relays she encounters. The protocol ends with Bob collecting the chunks. Alice may encode her data before the dissemination. Willie can either perform random walks as Alice and Bob do or conduct uniform surveillance of the area. In either case, he can only observe one relay at a time. We evaluate the system performance by the covertness probability and the message passing delay. In our protocol, Alice splits her message to increase the covertness probability and adds (coded) redundancy to reduce the transmission delay. The performance metrics depend on the graph, communications delay, and code parameters. We show that, in most scenarios, it is impossible to find the design parameters that simultaneously maximize the covertness probability and minimize the message delay.
Thanks to the availability of large bandwidth and high-gain directional antennas at the millimeter-wave (mmWave) bands, mmWave communications have been considered as one of the primary solutions to meet the high data rates needs in vehicular networks. Unicast in mmWave vehicle-to-vehicle (V2V) communications has been well-studied, but much less attention has been paid to V2V broadcast which is required by many V2V applications such as active safety. To fill the gap, this paper systematically investigates mmWave V2V broadcast by considering the unique properties of mmWave signal propagation in V2V environments as well as the impacts of directional antennas and interference. Based on widely-accepted, high-fidelity system models, we mathematically analyze the receiver-side signal-to-interference-plus-noise-ratio (SINR) and broadcast coverage, and we study the impacts of blockage, inter-vehicle distance, vehicle density and beam pattern. Through comprehensive numerical analysis, we find out that, instead of a single unique optimal beamwidth, there exists an optimal range of beamwidth, in which the beamwidths have similar performance and can maximize the coverage. We also find out that the selection of carrier sensing range plays an important role as it highly influences the performance of the whole vehicular networks. Our analysis provides unique insight into mmWave V2V broadcast, and it sheds light on designing effective V2V broadcast protocols.
In this paper, we investigate the performance of an intelligent omni-surface (IOS) assisted downlink non-orthogonal multiple access (NOMA) network with phase quantization errors and channel estimation errors, where the channels related to the IOS are spatially correlated. First, upper bounds on the average achievable rates of the two users are derived. Then, channel hardening is shown to occur in the proposed system, based on which we derive approximations of the average achievable rates of the two users. The analytical results illustrate that the proposed upper bound and approximation on the average achievable rate of the strong user are asymptotically equivalent in the number of elements. Furthermore, it is proved that the average achievable rates with correlated and uncorrelated channels are asymptotically equivalent for a large number of elements. Simulation results corroborate the theoretical analysis and show that the channel hardening effect appears even for a few elements. The impact of channel correlation on the system performance in terms of average achievable rates is negligible for a large number of elements.
We focus on the numerical modelling of water waves by means of depth averaged models. We consider in particular PDE systems which consist in a nonlinear hyperbolic model plus a linear dispersive perturbation involving an elliptic operator. We propose two strategies to construct reduced order models for these problems, with the main focus being the control of the overhead related to the inversion of the elliptic operators, as well as the robustness with respect to variations of the flow parameters. In a first approach, only a linear reduction strategies is applied only to the elliptic component, while the computations of the nonlinear fluxes are still performed explicitly. This hybrid approach, referred to as pdROM, is compared to a hyper-reduction strategy based on the empirical interpolation method to reduce also the nonlinear fluxes. We evaluate the two approaches on a variety of benchmarks involving a generalized variant of the BBM-KdV model with a variable bottom, and a one-dimensional enhanced weakly dispersive shallow water system. The results show the potential of both approaches in terms of cost reduction, with a clear advantage for the pdROM in terms of robustness, and for the EIMROM in terms of cost reduction.
Reconfigurable Intelligent Surface (RIS) draws great attentions in academic and industry due to its passive and low power consumption nature, and has currently been used in physical layer security to enhance the secure transmission. However, due to the existence of double fading effect on the reflecting channel link between transmitter and user, RIS helps achieve limited secrecy performance gain compared with the case without RIS. In this correspondence, we propose a novel active RIS design to enhance the secure wireless transmission, where the reflecting elements in RIS not only adjust the phase shift but also amplify the amplitude of signals. To solve the non convex secrecy rate optimization based on this design, an efficient alternating optimization algorithm is proposed to jointly optimize the beamformer at transmitter and reflecting coefficient matrix at RIS. Simulation results show that with the aid of active RIS design, the impact of double fading effect can be effectively relieved, resulting in a significantly higher secrecy performance gain compared with existing solutions with passive RIS and without RIS design.
In this paper, a massive multiple-input-multiple-output (mMIMO) testbed that is capable of mimicking realistic 5G new radio (NR) base station (BS) beamforming performance has been utilised to gather experimental-based evidence of 5G BS RF-EMF exposure within a real-world indoor environment. The mMIMO testbed has up to 128 RF channels with user-programmable software defined radio (SDR) capability. The stochastic nature of the 5G NR mMIMO system has been statistically assessed by evaluating the spatial variation of the RF-EMF exposure surrounding the mMIMO testbed when taking into account different beam profiles and data rates. Several other factors that influence the RF-EMF of mMIMO system have also being considered.
Molecular communication (MC) can enable the transfer of information between nanomachines using molecules as the information carrier. In MC systems, multiple receiver nanomachines often co-exist in the same communication channel to serve common or different purposes. However, the analytical channel model for a system with multiple fully absorbing receivers (FARs) does not exist in the literature, which is significantly different from the single FAR system due to the mutual influence of FARs. The analytical channel model is essential in analyzing systems with multiple FARs, including MIMO, SIMO, and cognitive molecular communication systems. In this work, we derive an approximate analytical expression for the hitting probability of a molecule emitted from a point source on each FAR on a diffusion-based MC system with three or more FARs. Using these expressions, we derive the channel model for a SIMO system with a single transmitter and multiple FARs arranged in a uniform circular array (UCA). We then analyze the communication performance of this SIMO system under different cooperative receiver schemes and develop several interesting insights.
The integrating factor technique is widely used to solve numerically (in particular) the Schr{\"o}dinger equation in the context of spectral methods. Here, we present an improvement of this method exploiting the freedom provided by the gauge condition of the potential. Optimal gauge conditions are derived considering the equation and the temporal numerical resolution with an adaptive embedded scheme of arbitrary order. We illustrate this approach with the nonlinear Schr{\"o}dinger (NLS) and with the Schr{\"o}dinger-Newton (SN) equations. We show that this optimization increases significantly the overall computational speed, sometimes by a factor five or more. This gain is crucial for long time simulations.
This project addresses the problem of sentiment analysis in twitter; that is classifying tweets according to the sentiment expressed in them: positive, negative or neutral. Twitter is an online micro-blogging and social-networking platform which allows users to write short status updates of maximum length 140 characters. It is a rapidly expanding service with over 200 million registered users - out of which 100 million are active users and half of them log on twitter on a daily basis - generating nearly 250 million tweets per day. Due to this large amount of usage we hope to achieve a reflection of public sentiment by analysing the sentiments expressed in the tweets. Analysing the public sentiment is important for many applications such as firms trying to find out the response of their products in the market, predicting political elections and predicting socioeconomic phenomena like stock exchange. The aim of this project is to develop a functional classifier for accurate and automatic sentiment classification of an unknown tweet stream.
小貼士
登錄享
注冊地址： 北京市海淀區羊坊店路18號2幢3層301-191